JK Wrangler ('12 - Current) sPod Mount & Vacuum Pump Relocation Kit
JK Wrangler sPod Mount and Vacuum Pump Kit


 
The JK "sPod" MOUNT & VACUUM PUMP RELOCATION KIT for the 2012 and later model Wranglers, moves the Vacuum Pump (located by your front frame rail) up into the engine compartment and provides a mount for the popular sPod Wiring System.

Relocating the vacuum pump is a necessary project to allow fitment of the MetalCloak JK Frame-Built Bumper System or any other bumper that allows your winch to sit low between the frame rails.

With the ever-growing popularity of the sPod, our original Vacuum Pump Relocation Bracket could interfere with the sPod mount, so we solved the problem by combining the two!

: $69.00

Availability: Usually Ships in 1 Week
Product Code: 3151


 
Features Specifications & Materials Installation Instructions
 
Dividing Line

JK SPOD VACUUM PUMP RELOCATION KIT

The 2012 and later model JK's have a vacuum canister located off the inside of the front frame rails.

This canister is located right where most bumpers put the winch on a JK.

This simple and effective relocation bracket moves the canister up to the engine compartment providing the needed space and then adds extra value by creating the perfect spot to mount an "SPOD" source unit in your JK.

Note: Moving the canister here does not compromise any of your Jeep's systems.

JK Spod Vacuum Pump Kit
Dividing Line

TESTIMONIALS & BUZZ:


Check out what Jeepers everywhere are saying about our products on The Buzz Page.
Dividing Line
Customers who bought this were also interested in...
6in Arched Front Flare 8in Overline Front Flare 6in Arched Front Flare 6in Arched Front Flare

Dividing Line


Average Customer Review: 5 of 5 Total Reviews: 18 Write a review.

  0 of 0 people found the following review helpful:
 
Works well! February 8, 2018
Reviewer: Dallas from Henderson, NV United States  
Works well

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
December 17, 2017
Reviewer: Jesus Garcia from El Cajon, CA United States  
Great product. Very good customer service. Really fast shipping. Will continue to buy metalcloak to finish my build

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Spod/Vacuum mount December 15, 2017
Reviewer: Tyler Christiance from Veneta, OR United States  
As with everything else from MetalCloak the bracket was very high quality and install was a breeze.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Sturdy upgrade May 11, 2017
Reviewer: Richard Sebring from Madera, CA United States  
I picked this up because I didn't like the way the bracket supplied with the sPOD was supported only from the fender side. It flops around a bit and you end up having to hold it while screwing down the terminals. This replacement is extremely sturdy and is secured on both sides.

Was this review helpful to you?

  1 of 1 people found the following review helpful:
 
Solid Mount Needs Updating January 23, 2017
Reviewer: David Artinian from Agoura Hills, CA United States  
Nice solid mount but I had to cut up my factory sPod mount and put it between sPod and Meatalcloak plate and cut out the case clip tabs from the Metalcloak plate.
This has to be done to support the rubber seal that is otherwise unsupported, by the fact that the Metalcloak bracket is cut away in a needed spots of support.

Was this review helpful to you?

View All Customer Reviews