Low Profile LED Marker Lights, JK
MetalCloak Low Profile Marker Lights


 
MORE PRODUCT IMAGES:
Actual product received may vary in minor ways from product rendering.


MetalCloak JK Wrangler Low Profile LED Marker Lights
  • (2) 3/4" LED Marker Lights
  • Mounting Hardware
  • (2) MetalCloak Decals

: $29.00

Availability: Usually Ships in 1 Week
Product Code: 2208-JK

Features Specifications & Materials Installation Instructions
 

JK LOW PROFILE LED MARKER LIGHTS

  • 2 bright, 12 volt, single bulb AMBER LEDs
  • Fits in standard MetalCloak front fenders
  • 3/4" light with rubber gasket housing
  • Wiring instructions listed here.

TJ Crawler Cap
Dividing Line
Customers who bought this were also interested in...

Dividing Line


Average Customer Review: 5 of 5 Total Reviews: 85 Write a review.

  0 of 0 people found the following review helpful:
 
Marker lights November 10, 2018
Reviewer: John Littrell from Alex, OK United States  
Extremely bright and fits perfect

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
LED marker lights for front fenders November 7, 2018
Reviewer: Greg Stroup from Levittown, PA United States  
They are the perfect size and awesome quality like all Metalcloak products.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Marker lights October 22, 2018
Reviewer: Jim Gavin from El Cajon, CA United States  
Excellent, easy install. Very bright.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
October 17, 2018
Reviewer: Cory B from LaGrange, NC United States  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Connections October 11, 2018
Reviewer: Jacob Reczek from Grovetown, GA United States  
Directions on installing the LED Lowprofile side markers were ok except for the wiring portion. I would love to see an improvement on the bullet connectors with and easier to install connector. They are set up so that you can wire them into your blinkers as well but I could not find decent instructions on how to do this. If there is a video out there could you consider creating a link to it on your instructions page similar to how you used the overline fender video from Jason at auto edits  channel!!

Was this review helpful to you?

View All Customer Reviews